110689 Active Task List Scan Version: V01090 Submitted by: Jim Lemasters, Bunker Ramo Electronic Systems, Westlake Village, CA Operating System: IAS V3.1 Source Language: MACRO-11 Memory Required: 4KW Hardware Required: VT100 Terminal, AVO (optional). Memory Management required for the FREE MEMORY count to function. Keywords: System Management - IAS Abstract: The Active Task List Scan task, ATS, displays the Active Task List (ATL) on a VT100 terminal. The tasks are displayed in the same format as the IAS ACT task, i.e., task name, current state, and terminal name, in priority order. The task list is arranged in columns of up to 19 tasks and up to 4 columns. ATS displays in the top 2 lines of the screen the current system time, number of free nodes, largest hole, amount of free memory, and number of errors logged by ERRLOG. Low node count warning messages are displayed on the bottom of the screen. The display update interval, initially set to 1 second, can be dynamically modified. A specific task and/or terminal name can be monitored as well as the initial update interval set by optional switches on the MCR command line. Notes: Task State Table might need to be modified for later versions. Restrictions: Implemented and tested on RSX-11M V4.0, will also run on VAX/VMS in compatibility mode except that shared files may not be opened with write access, due to restrictions of the compatibility mode emulation. PASMAC.MAC (a MACRO definitions module for PASCAL-2) belongs to Oregon Software, but is supplied with each PASCAL-2 license. Media (Service Charge Code): One RX01 Diskette (KA) Format: RT-11, 600' Magnetic Tape (MA) Format: DOS-11